How Much Glue Should I Apply to the Glue Tab?
The ideal amount of glue for each tab varies based on size. As a general rule, you should fill the entire surface of the tab. Once applied, you should notice…Read more »
Why Won’t My Glue Tabs Stick to the Panel?
Following our 6C process ensures optimal adhesion every time and can resolve most common issues. A few of the most common reasons for glue not sticking are…Read more »
How Do I Remove Glue from Panels and Glue Tabs?
Glue is easily released using a high concentration form of isopropyl alcohol sprayed directly on the glue. This allows glue to be removed cleanly by…Read more »
How Hard Should I Press Down when Applying a Glue Tab to the Panel?
When applying the glue tab to the panel, it is best to set the tab within a layer of glue similar to a brick placed in mortar. The tab should have an even layer of glue all the way around the edge with plentyRead more »
How to Ensure Correct Glue Tab Placement on Damaged Panel?
We recommend using a grease pencil or marker to clearly mark the edges of the damage when viewing with a line board, fog board or other PDR light. Technicians can then easilyRead more »
- crease dent
- slide hammer
So far I tested the the tabs over a shallow crease dent. Pulled by a slide hammer. Initial thoughts were they pull more towards the center then a slight high going both directions from the center.