How Much Glue Should I Apply to the Glue Tab?
The ideal amount of glue for each tab varies based on size. As a general rule, you should fill the entire surface of the tab. Once applied, you should notice…Read more »
Why Won’t My Glue Tabs Stick to the Panel?
Following our 6C process ensures optimal adhesion every time and can resolve most common issues. A few of the most common reasons for glue not sticking are…Read more »
How Do I Remove Glue from Panels and Glue Tabs?
Glue is easily released using a high concentration form of isopropyl alcohol sprayed directly on the glue. This allows glue to be removed cleanly by…Read more »
How Hard Should I Press Down when Applying a Glue Tab to the Panel?
When applying the glue tab to the panel, it is best to set the tab within a layer of glue similar to a brick placed in mortar. The tab should have an even layer of glue all the way around the edge with plentyRead more »
How to Ensure Correct Glue Tab Placement on Damaged Panel?
We recommend using a grease pencil or marker to clearly mark the edges of the damage when viewing with a line board, fog board or other PDR light. Technicians can then easilyRead more »
|Length||2.8" / 70 mm|
|Width||1.2" / 31 mm|
Got the job done were other tabs did not
Strong precise pulls right from the start First Pull removed a good portion of the debt effortlessly The second pull I did a wet pull because afraid the tab was too strong got in Can cleaned up the last 10% with a PDR ROD repair tie. reduced significantly thx to the gang green tabs
Right out out the gate first pull removed 80% Second pull pulled to a high ridge with so much power Knocked it down.with a tap and cleaned up with a PDR Tool from the back side Would normally would take me about a half hour with a PDR tool the gang green glue pulltab did and half the time Thx Gang Green Tabs and the Keco team
Excellent tab Strong pulls
Really like gang green tabs. Great for strong pulls!