How Much Glue Should I Apply to the Glue Tab?
The ideal amount of glue for each tab varies based on size. As a general rule, you should fill the entire surface of the tab. Once applied, you should notice…Read more »
Why Won’t My Glue Tabs Stick to the Panel?
Following our 6C process ensures optimal adhesion every time and can resolve most common issues. A few of the most common reasons for glue not sticking are…Read more »
How Do I Remove Glue from Panels and Glue Tabs?
Glue is easily released using a high concentration form of isopropyl alcohol sprayed directly on the glue. This allows glue to be removed cleanly by…Read more »
How Hard Should I Press Down when Applying a Glue Tab to the Panel?
When applying the glue tab to the panel, it is best to set the tab within a layer of glue similar to a brick placed in mortar. The tab should have an even layer of glue all the way around the edge with plentyRead more »
How to Ensure Correct Glue Tab Placement on Damaged Panel?
We recommend using a grease pencil or marker to clearly mark the edges of the damage when viewing with a line board, fog board or other PDR light. Technicians can then easilyRead more »
|Length||0.6" / 15 mm|
|Width||0.6" / 15 mm|
These are great, the pull hard
Used these and my Keco tabs to pull deep hail dent out of a mini hood.
Have a lot of small dents left after pulling big ones. Was worried that these would not have a large enough surface area to make a good pull. Have been pleasantly surprised how well they pull even with cheap glue.
I’m a novice at PDR. As such I’ve struggled with getting the tabs to stick, or just work. That is until I found Gang Green Tabs. I had a shopping cart dent behind a door on my car. In less than an hour with the proper equipment, the dent was invisible. Good stuff
Got the job done were other tabs did not